MAX1446
10-Bit, 60Msps, +3.0V, Low-Power
ADC with Internal Reference
______________________________________________________________________________________ 13
the input. Although a 1:1 transformer is shown, a step-
up transformer may be selected to reduce the drive
requirements. A reduced signal swing from the input
driver, such as an op amp, may also improve the over-
all distortion.
In general, the MAX1446 provides better SFDR and
THD with fully differential input signals than single-
ended drive, especially for very high input frequencies.
In differential input mode, even-order harmonics are
lower since both inputs (IN+, IN-) are balanced, and
each of the inputs only requires half the signal swing
compared to single-ended mode.
Single-Ended AC-Coupled
Input Signal
Figure 9 shows an AC-coupled, single-ended applica-
tion. The MAX4108 op amp provides high speed, high
bandwidth, low noise, and low distortion to maintain the
integrity of the input signal.
Grounding, Bypassing,
__________________and Board Layout
The MAX1446 requires high-speed board layout design
techniques. Locate all bypass capacitors as close to
the device as possible, preferably on the same side as
the ADC, using surface-mount devices for minimum
inductance. Bypass V
DD
, REFP, REFN, and COM with
two parallel 0.1µF ceramic capacitors and a 2.2µF
bipolar capacitor to GND. Follow the same rules to
bypass the digital supply (OV
DD
) to OGND. Multilayer
boards with separated ground and power planes pro-
duce the highest level of signal integrity. Consider
using a split ground plane arranged to match the physi-
cal location of the analog ground (GND) and the digital
Comments to this Manuals