Rainbow-electronics GE863-GPS low power User Manual download pdf (Page 46)

GE863-GPS Software User Guide

1vv0300724 Rev. 3 - 05/07/07

3.2.3.1 CLIR Service status query

•

send command

AT+CLIR?<cr>

•

wait for response in the format:

+CLIR: <n>,<m>

where:

<n> is the facility status on the Mobile

0 – CLIR facility according to CLIR service network status

1 – CLIR facility active (CLI not sent)

2 – CLIR facility not active (CLI sent)

<m> is the facility status on the Network

0 - CLIR service not provisioned (service unavailable)

1 - CLIR service provisioned (service available)

2 - unknown (e.g. no network present, etc.)

3 - CLI temporary mode presentation restricted

4 - CLI temporary mode presentation allowed

NOTE: The <m> parameter reports the status of the service at network level.

If the CLIR service is not provisioned, then it is not possible to use this service and changing

the first parameter <n> will not change the CLI presentation to the other party behavior of the

network.

For example:

1- Let's assume you want to check your CLIR settings:

command:

AT+CLIR? <cr>

response:

+CLIR: 2,4

In this case the CLIR service is temporary mode allowed on the network and the mobile sends the CLI

when calling. (CLI Restriction not active).

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 121 122

No comments

Rainbow-electronics GE863-GPS low power User Manual Page 46