Rainbow-electronics AT86RF211 User Manual download pdf (Page 43)

AT86RF211

1942C–WIRE–06/02

Synthesizer

Specification

Unless otherwise specified, data is given for T = 25°C, V

SUPPLY

=2.7V

Notes: 1. Crystal frequency can be slightly changed but since IF2 = IF1 - Crystal frequency, IF2 will shift and must remain within the

IF2 filter and discriminator bandwidth.

2. With the "typical implementation" loop filter.

Receiver Specification Unless otherwise specified, data is given for T = 25°CV

SUPPLY

=2.7V

Note: 1. The overall sensitivity depends on measurements conditions and external components, i.e.:

-100 dBm for BW = ± 10 kHz, ∆F = ± 7.5 kHz, Brate = 4800 bps with RF switch used and external SAW filter

Parameter Min Typ Max Unit Comments

Frequency Range 400 480 MHz Digital programming

Frequency Range 800 950 MHz Digital programming

Crystal Frequency 10.235 10.245 10.255 MHz IF 1 = 10.7 MHz

(1)

Crystal Frequency 20.925 20.945 20.965 MHz IF 1 = 21.4 MHz

(1)

Oscillator Settling Time 5 8 ms Depending on crystal

specifications

Lock Time

(2)

300 µs From oscillator settling

Lock Time

(2)

30 µs 100 kHz shift

Phase Noise 400 to 480 MHz -80 dBc/Hz At 10 kHz from the carrier

Phase Noise 800 to 950 MHz -75 dBc/Hz At 10 kHz from the carrier

Phase Noise 400 to 480 MHz -91 dBc/Hz At 100 kHz from the carrier

Phase Noise 800 to 950 MHz -86 dBc/Hz At 100 kHz from the carrier

Parameter Min Typ Max Unit Comments

IF1 10.7 MHz 21.4 MHz also possible

IF1 Filter Impedance 330 Ω

IF2 455 kHz

IF2 Filter Impedance 1700 Ω

FSK Sensitivity -105 dBm Typical performance with a BER of 1% at input pin

RXIN(45).BW=±10kHz,∆F = ± 7.5 kHz; Brate =

4800 bps

(1)

Noise Figure 15 dB Input matched, complete RX chain

Input IP3 -15 dBm

Max Input Power -5 dBm BER < 10%

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Comments to this Manuals

No comments

Rainbow-electronics AT86RF211 User Manual Page 43

Comments to this Manuals

Related products and manuals for Wireless Headsets Rainbow-electronics AT86RF211